2010 Ford stuck in low range quick Diag @ThePracticalMechanic
2010 Ford stuck in low range quick Diag  @ThePracticalMechanic
Uploaded December 2021 | Updated November 2026, 3 hours ago
Quick test with lab scope connected to the transfer case shift motor control wires to see why we can hear clicking from the control module relays but the transfer case is not shifting out of low range. On the lab scope we see both wires going to the transfer case switch at the same potential, both wires go to power and both wires go to ground. This is an indication that the control module is failing to pull one of the wires to ground when the other wire is switched to power.

I connected a lightbulb from ground to one of the transfer case control wires to see if I can add a supplemental ground and get a different Reaction from the transfer case shift motor. The result was the truck shifted out of low range into 2hi. Before it was stuck in four wheel low. This points towards a failure inside the 4 x 4 control module.
2010 Ford stuck in low range quick Diag1997 Toyota Camry Denso Starter Contact failure with scope captures2014 Toyota RAV4 maintenance light reset with blade style ignition key.Weekly Waveform 5 - Invert, AC couple, ignition sync, relative compression2004 BMW 325i Fuel gauge doesnt work   PHAD Fix1960 Chevy Biscayne LS Swap Ep 33 - Checking Drive Shaft Fitment and Modification Ideas.2011 Dodge Ram Poor AC Performance - Filter drier service2008 Toyota Sienna HVAC repair - Rear air blow on high - broken ribbon cable1993 Infiniti J30 Rough Running DiagnosticWeekly Waveform 3 - Starting system amperageStarter solenoid Pull-in and Hold-in coils explained and testedLive New Years Goals- Personal and Work related- Training talk
ThePracticalMechanic |

2010 Ford stuck in low range quick Diag

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER