2011 Dodge Ram Poor AC Performance - Filter drier service @ThePracticalMechanic
2011 Dodge Ram Poor AC Performance - Filter drier service  @ThePracticalMechanic
Uploaded July 2022 | Updated November 2026, 3 hours ago
This is the second truck I have service in as many weeks that had the same issue. The first truck was actually building up enough pressure to discharge from the pressure relief port.
This truck is exhibiting poor AC performance and was 0.5 lbs low on refrigerant. The radiator had no build up or restriction and there were no visible leaks. When the pressures still weren't normal I was give the vehicle to diagnose.
I always like to look at the pressures to see if the compressor is working and also to see if the cooling fans are lowering the high side pressures adequately. This vehicle had the opposite problem when looking at the gauges. The high side pressure was too low and it actually dropped below the static pressure readings taken before start up.
The high side pressure dropped down to 70psi while idling with the AC turned on. The normal high side pressure is between 200 and 350 psi. Using the scan tool we can compare the pressure sensor readings at the compressor to the pressures measured at the high side service port.
What we found was a large discrepancy. This is caused by a restriction between the pressure sensor and the high side service port and the only thing between these two items is the AC condenser which happens to contain the filter/drier. Using the thermal imager we can determine where the blockage is and on this vehicle is was apparent that the blockage is at the filter/drier. After replacing the filter drier our pressures are much better but there is still some room for improvement. The condenser still has some slight restriction and the system will likely need replaced in the future.
2011 Dodge Ram Poor AC Performance - Filter drier service2008 Toyota Sienna HVAC repair - Rear air blow on high - broken ribbon cable1993 Infiniti J30 Rough Running DiagnosticWeekly Waveform 3 - Starting system amperageStarter solenoid Pull-in and Hold-in coils explained and testedLive New Years Goals- Personal and Work related- Training talkLive 1996 Toyota 4runner cylinder head removal.2004 Toyota 4Runner ZERO Point Reset - ThinkDiag 22005 Subaru Forester Pt 5 Cylinder head installation1960 Chevy Biscayne LS Swap Ep 27 - Transmission Cooler lines 4L60E2 Channel Scope for Dummies- A Guide to Using a Oscilloscope with the Launch Torque 5Weekly labscope learning project update - See one, do one, teach one
ThePracticalMechanic |

2011 Dodge Ram Poor AC Performance - Filter drier service

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER