Fusion 360 | Surrogate Emboss @Fusion360School
Fusion 360 | Surrogate Emboss  @Fusion360School
Uploaded July 2021 | Updated November 2026, 4 days ago
The emboss command can only be performed on surfaces with curvature in one direction. Is there a way we can use it for surfaces with curvature in 2 directions? Take note that the method shown here does not produce a true geometrical wrap. It only creates an illusion of a wrap.

The file can be downloaded at the following link. It contains the parent and surrogate bodies as well as all the necessary sketches.
a360.co/3yZsoY2

If you have found this video useful and would like to support me, you can buy me a coffee at
buymeacoffee.com/fusion360school
or you can also support me on Patreon at
patreon.com/fusion360school?fan_landing=true

Any contribution can go towards improving the quality of the channel. Thank you.

#fusion360school
#fusion360SurrogateEmboss

0:00 Intro
1:06 Parent and surrogate bodies
1:56 Splitting of pattern region
2:37 Sketch pattern
5:33 Emboss
6:22 Offset
7:04 Thicken cut
Fusion 360 | Surrogate EmbossFusion 360 - Case Study 10Fusion 360 - Visualisation | Surface PatchworkFusion Quick Bites #2Fusion 360 - Case Study 8Fusion 360 | Limited Staggered Slot PatternAutodesk Fusion | Mind The GapAutodesk Fusion | Sketch AutoConstrain (Commercial Subscription Only)Autodesk Fusion | Limited mesh patternFusion 360 | Extrude Presets (only with Product Design Extension)Fusion 360 | Master Model WorkflowFusion 360 | Groove on cylinder (with parallel side walls)
Fusion 360 School |

Fusion 360 | Surrogate Emboss

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER