Uploaded January 2026 | Updated September 2026, 2 weeks ago
Doing some flow tests with a flat bar.
Tops are very important.
Sunlu ABS 0.4 TC nozzle, Chube conduction, vzhex brass gear, Moons 10T extruder motor.
.2 Layer height, .5 line width, ~800mms (volumetric speed
Making one more test at .3 layer height, same flow, which will result in less speed. I want to see if the result is the at the same flow point.
** Printed another with .3 layer height, much worse result at 78mms3 flow. Probably somewhere in the 67mms3 range in comparison.
Doing some flow tests with a flat bar.
Tops are very important.
Sunlu ABS 0.4 TC nozzle, Chube conduction, vzhex brass gear, Moons 10T extruder motor.
.2 Layer height, .5 line width, ~800mms (volumetric speed
Making one more test at .3 layer height, same flow, which will result in less speed. I want to see if the result is the at the same flow point.
** Printed another with .3 layer height, much worse result at 78mms3 flow. Probably somewhere in the 67mms3 range in comparison.
