DIY CNC - Z Axis Design, Construction and Router Mounting @GregsGarage
DIY CNC - Z Axis Design, Construction and Router Mounting  @GregsGarage
Uploaded August 2015 | Updated November 2026, 3 hours ago
Let's take a look at how the Z Axis will work and how router is going to mount to it. I had to approach this problem just a bit differently than I initially thought, but it looks like everything is going to work out.

Dupont PCB Crimper too here: ebay.to/1Yy1VJt
Buy the Arduino & Shield here: ebay.to/1jnHdMr
Buy the Stepper Motors here: ebay.to/1Ngc89u
24V Power Supply here: ebay.to/1Pg55zZ
Lead Screws here: ebay.to/1lloSB1

The router I'm using is a Bosch Model 1617EVS 2-1/4 HP fixed base unit. I picked it because it was small and had a variable speed motor. The sleeve also allows the router to slip back in upside down.

Follow me on social media

Facebook - facebook.com/gregsgaragekc
Twitter - twitter.com/steelsplinters
Instagram - instagram.com/gregsgaragekc
DIY CNC - Z Axis Design, Construction and Router MountingGuitar Build - Part 5 - Truss RodRouter Table - Table Saw Extension - Part 2Broken Garage Door Spring - Fixing it YourselfGuitar Setup Tool DesignGuitar Build - Part 18 - Body Part 2Western Electric Footswitch RestorationCustom Guitar Bridge - Guitar Build Part 30Final Race Prep - 1932-1933 Studebaker Indy CarStructural Footwell Repairs - 356 RestorationV-Carve Inlays - Detailed How ToMassive Collet Wrench
Gregs Garage |

DIY CNC - Z Axis Design, Construction and Router Mounting

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER