V-Carve Inlays - Detailed How To @GregsGarage
V-Carve Inlays - Detailed How To  @GregsGarage
Uploaded July 2017 | Updated November 2026, 3 hours ago
Let's get up close and personal with inlay settings in V-Carve. Its an easy process if you know what all the settings control. My personal notes are below:

Tools (affiliate links to amazon)
60 DEGREE V-BIT - amzn.to/2vkOZ3k
1/4" SPIRAL COMPRESSION BIT - amzn.to/2funEq1
1/8" SPIRAL DOWNCUT BIT - amzn.to/2vGwBmf
3/4" RESAW BLADE FOR BANDSAW - amzn.to/2fudJRh

For the Inlay (Plug)...
1. Mirror the vectors in your graphic so you have a mirror image.
Set your "Start Depth" to .1. This ensures you have .1" of material that sits down into the pocket.
2. Set the "Flat Depth" to .1". The .1" here adds to the .1" of start depth, so the emboss will be .2" deep. Since .1" will go INTO the pocket. This will leave a .1" gap between the pieces for the band saw to pass through after the glue up.

On the CNC router...

Carve the inlay (plug) normally starting with the V-bit (60 degree preferably)

Pocket...

1. The v-carve is business as usual except, set the flat depth to .2 inches and use an 1/8 end mill for the flats. (this makes sure the v-bit only goes .2" into the work as that is the maximum cutting height for a 60 degree, 1/4" bit.

On the CNC router...

Zero the machine at the Origin.
If you want some sanding allowance, Add .01" to the Z height. (This will cheat the pocket to be .21" deep. This will allow the inlay to go in slightly deeper so you'll have .01" to be able to sand the surface to the right depth for the graphic's detail.)

Follow me on social media

Facebook - facebook.com/gregsgaragekc
Twitter - twitter.com/steelsplinters
Instagram - instagram.com/gregsgaragekc
V-Carve Inlays - Detailed How ToMassive Collet WrenchSUPER CHEAP DIY Fogbuster Coolant System - Tormach 11001969 Amc Rambler UpdateGuitar Build - Part 14 - Cutting the VeneerNissan 3.5L - Radiator and Thermostat ReplacementSave $700 on Ford F150 Crankshaft Sensor ReplacementMetal Flake Gun for $15 - ????$*#t Welders SayYou Can Make a Compound Radius Fretboard Easily - Guitar Build - Part 9Guitar Build - Part 15 - HeadstockB-Pillar Patch Panel - Welding and Finishing - 356 Project
Gregs Garage |

V-Carve Inlays - Detailed How To

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER