Uploaded November 2015 | Updated September 2026, 5 hours ago

---

Subscribe: goo.gl/FmlHU7

00:02 Measuring a piece of clear flexible UPVC around circumference of CNC extraction hood.
00:29 Roughly cut to size, making sure the depth of the flaps are a bit larger.
01:17 Cutting flaps using an engineers square to provide spacing.
01:53 I am going to secure this on with machine screws.
01:58 I place the UPVC against the circumference of the hood and mark the two most outer points.
02:07 I punch one holes through, and drill and tap one machine screw to check it will hold.
02:43 I use the divider to make the holes I in-between.
03:16 I work along the length of the UPVC, punching, drilling , tapping and securing with the machine screw.
04:02 I set up the machine and test. The flaps are a little too long and need cutting down.
04:37 Using a straight edge I cut the flaps down.
05:13 I tested the new hood flaps and something else went wrong.

Main Channel: youtube.com/SavvasPapasavva
Instagram: instagram.com/savvas_papasavva
Twitter: twitter.com/savvasPapasavva
Website: miscpro.com

This was the last thing I filmed before coming to the conclusion that I needed to rebuild this machine.