Uploaded June 2017 | Updated September 2026, 2 hours ago

---

In this video I troubleshoot and debug some the problems with my CNC machine and the enclosure:

0:29 - Measure between limits by enabling hard limits
0:55 - Setting steps on drivers and in software (b-CNC)
04:01 - Three of the four motor couplers do not hold when machine is in idle
06:21 - Stepper motor delay when Estop pressed
09:27 - Check how square X and Y axes are and adjust
11:01 - Cut into sub waste-board and set insert nuts, fit waterboard, surface MDF.
14:29 - What I edited in GRBL V0.9 Config.h
15:43 - Re-wiring Estop

The Spoil Board Surfacing Bit I used: routercutter.co.uk/spoilboard-surfacing-635mm-shank

Subscribe: goo.gl/FmlHU7

Patreon: patreon.com/EducatingSavvas

Photo Updates at Instagram: instagram.com/savvas_papasavva
Main Channel: youtube.com/SavvasPapasavva
Nothing happens on Twitter: twitter.com/savvasPapasavva
Website: miscpro.com