Uploaded May 2022 | Updated September 2026, 2 weeks ago
So to do all this is super simple just takes some time all your gonna need is the parts down below but feel free to try other parts connectors mosfets etc... Use what you think is the best just be sure to use right gauge of wire when needed. Also feel free to use a higher c-rated battery I used the lowest of the tenergy 7.4v lipo batterys available as long as they are the nano techs they should all fit I believe.. Some notes be sure to store your battery's at resting voltage I leave mine at 7.65 when im not gonna use it for awhile. last note during the b-roll I fired indoors at battery resting voltage so it wasn't fully charged but I can promise its as fast if not faster then before i'll chrono it sometime and post the numbers.
-----------------------------------------------------------------------------------------------------------
Get the charger I used here " amazon.com/Crazepony-Balance-Charger-Connector-Quadcopter/dp/B09NNLZBPD/ref=sr_1_5?keywords=lipo%2Busb%2Bcharger&qid=1649816489&sprefix=lipo%2Busb%2B%2Caps%2C166&sr=8-5&th=1 "
-----------------------------------------------------------------------------------------------------------
Get the battery I used here if not available order on ebay still cheaper then the nimh ones. " hobbyking.com/en_us/turnigy-nano-tech-300mah-2s-35-70c-lipo-pack.html "
-----------------------------------------------------------------------------------------------------------
Get the mosfet I used here JEFTRON MICRO MOSFET II
You can use the pre-wired one or the unwired one which is what I used
" jefftron.net/mosfet/micro-mosfet-ii "
-----------------------------------------------------------------------------------------------------------
Please Visit: " everythingdigital1.com "
So to do all this is super simple just takes some time all your gonna need is the parts down below but feel free to try other parts connectors mosfets etc... Use what you think is the best just be sure to use right gauge of wire when needed. Also feel free to use a higher c-rated battery I used the lowest of the tenergy 7.4v lipo batterys available as long as they are the nano techs they should all fit I believe.. Some notes be sure to store your battery's at resting voltage I leave mine at 7.65 when im not gonna use it for awhile. last note during the b-roll I fired indoors at battery resting voltage so it wasn't fully charged but I can promise its as fast if not faster then before i'll chrono it sometime and post the numbers.
-----------------------------------------------------------------------------------------------------------
Get the charger I used here " amazon.com/Crazepony-Balance-Charger-Connector-Quadcopter/dp/B09NNLZBPD/ref=sr_1_5?keywords=lipo%2Busb%2Bcharger&qid=1649816489&sprefix=lipo%2Busb%2B%2Caps%2C166&sr=8-5&th=1 "
-----------------------------------------------------------------------------------------------------------
Get the battery I used here if not available order on ebay still cheaper then the nimh ones. " hobbyking.com/en_us/turnigy-nano-tech-300mah-2s-35-70c-lipo-pack.html "
-----------------------------------------------------------------------------------------------------------
Get the mosfet I used here JEFTRON MICRO MOSFET II
You can use the pre-wired one or the unwired one which is what I used
" jefftron.net/mosfet/micro-mosfet-ii "
-----------------------------------------------------------------------------------------------------------
Please Visit: " everythingdigital1.com "
