Uploaded January 2026 | Updated September 2026, 2 weeks ago

---

I have wanted to try this for more than a year and it did not disappoint... well one didn't.
Help support this channel! patreon.com/Needitmakeit

Metal Melting Electric Furnace - amzn.to/45aG1WY
6.6lb Clay Graphite Crucible - amzn.to/4jQ4Yx0 (The one for the waste)
Graphite Bar Molds - amzn.to/4jQ4Yx0

A short list to help support this channel, thank you so much for your help!
Bambu H2C - tidd.ly/3K3sSY9 (If you print with color, this is the way)
Bambu P2S - tidd.ly/3ISZkfq (Best value)
Bambu H2S - tidd.ly/4olSRbL (Most options for money)
Bambu H2D - tidd.ly/4q9RsHk (A dual color beast)
Bambu Filament Shown in Videos - tidd.ly/4hn6TYI
Rode Wireless ME mic (Saved me about 4+ hours/vid) - amzn.to/3vcMKAr
Mag clip (Super handy, but a little pricy) - amzn.to/3NBFvZe

I haven't done much metal casting lately and I had been missing it. I have a project coming up where these castings are going to be used and I wanted to get the best results possible. Casting using lost foam works, but it can produce rough results, but casting in plaster normally requires a burnout process, and I don't have a furnace for that. I have a couple of ideas that I share in this video which I think will solve that problem.

#metal
#3dprinting
#h2c