Assembly and Installation of the Draft Stopper 3.0 @UDoIt2
Assembly and Installation of the Draft Stopper 3.0  @UDoIt2
Uploaded August 2025 | Updated September 2026, 3 weeks ago
Our door has a gap in it and I felt it was finally time to get a draft stopper. I found this product and bought it. The product comes with 6 foam rolls, tape to join the rolls together, adhesive pads, and the draft stopping carcass.

The version I bought is 4 inches too long for my door so I cut the foam rolls that were provided down to the length according to the instructions. Using the provided adhesive tape, I connected the three rolls together end to end and installed in the draft stopping carcass. Once fully assembled, I installed the draft dropper under the door.

Suggested Tools and Materials:
- Tape Measure
- Scissors - amzn.to/4lnu0CC
- MAXTID Draft Stopper - amzn.to/45o8M1w

“As an Amazon Associate I earn from qualifying purchases.”

Video Credits:
Video Production: U Do It™️ Studios a Division of No Cheese Records LLC All Rights Reserved. No Cheese Records® is a Registered Trademark of No Cheese Records LLC All Rights Reserved.
Assembly and Installation of the Draft Stopper 3.0Wood Is Good Podcast Forum with Florida WoodworkersWhy does it never work out the way you planned? #PlasmaCNCUDoit Fabricates - Truck Bed Extender for Long Loads - Ep. 1Save money by rebuilding your grill burnersHow to install a GFI outlet in basement from start to finishHow to install LEDs behind TVHow to setup the Rode PSA1 boom armHow to Replace Battery on Craftsman LT2000 Riding LawnmowerHow well does the MUTAOMAY pressure washer cleanUDoIt Reviews Furniture - Bon Augure Rustic Oak BookshelfAdjusting clamping system for repeatable center drilling #metalfabrication
U Do It |

Assembly and Installation of the Draft Stopper 3.0

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER