Arete Supercar Project update and June 2020 shop tour @BuilderCreator

Uploaded June 2020 | Updated September 2026, 1 week ago

As June is upon us, we take a look around the Studio/shop to see what is going on. From horizontal stiffeners in the door seals of the Arete supercar Project , to some new foundry equipment and a discussion about slot and tab assemblies in the fabrication process. All part of what it takes to build a scratch built supercar from the ground up. Bonus- story of our new audio quality.

Work For It podcast link: megaphone.link/TMN3299233098

#BuilderCreator #AreteGT #ProgressTour #Supercar #DIY #CarBuild

Arete Supercar Project update and June 2020 shop tour

Koenigsegg sets a new bar for the Arete supercar project and we fab the bulkhead.

100 thousand people like supercars and overlanders and Jay Jarvies work ethic.

A89 Keeping it attached and directing the air. Under the bonnet substructure. Arete Supercar Project

A35 - Arete Supercar Project- Composite lamination to extend the side intake duct.

L18 Is that possible? An Aerodynamic Overlanding truck? With @AirShaper

A39 - Arete Supercar project- Chromoly magic- Front A-Arm re-envisioned and fabricated.

Arete Supercar project - laminating reinforcement points for the sub-frames

Why Im building the monocoque tub layer by layer. Arete supercar project.

A15 - Taking molds for our supercars doors

A22 - Muffled screams! At 7000 RPM. Building a custom muffler for the Arete Supercar.

Creative Space - A supercar builders shop tour