Analog Devices ADEMA127 Evaluation Board - Unboxing | DigiKey @DigiKeyProductDiscovery
Analog Devices ADEMA127 Evaluation Board - Unboxing | DigiKey  @DigiKeyProductDiscovery
Uploaded October 2026 | Updated November 2026, 3 hours ago
We take a look at the ADEMA127 evaluation board from Analog Devices. It provides 7 simultaneously sampling ADC channels and is designed for polyphase or split-phase energy metering.

Inside the box, you’ll find the ADEMA127 evaluation board, a controller board, and 4 current transformers.

In this demo we’re going to connect to the board using ADI’s ACE software, which we can use to configure the ADEMA127 and capture measurement data. Before beginning, you need to install the USB to UART bridge drivers, ACE, and the board and chip plugins for ADEMA127. You also may need to update the firmware on the control board. Details are in the Github repo.

Plug the controller board into the ADEMA127 evaluation board and connect your PC to the control board’s micro USB port. Connect the current transformers to the terminal blocks, and plug voltage probes into the banana jacks.

In ACE, click the add hardware button, and add a serial port with a 921600 baud rate. You can find the port number in device manager and in my case it’s COM8. Click OK and you should see the EVAL-ADEMA127 appear in a few seconds. If not, you may need to press the reset button on the control board. Double click the board and you’ll see a system view including the burden resistors for the current transformers, the attenuation for the voltage probe inputs, and the filters. Double click on the ADEMA127 and you can see and modify the settings for each channel. Then click proceed to analysis. Here you can run once or run continuously to gather data. I’ll run once and you can see the result from my probe attached to a simulated 50 hertz source.

github.com/analogdevicesinc/energy-adc-service/blob/main/eval_firmware/ace_firmware/ace_plugin_users_guide.md
digikey.com/en/products/base-product/analog-devices-inc/505/ADEMA12/742634
digikey.com/en/products/detail/analog-devices-inc/EVAL-ADEMA127KTZ/28245177

Maker.io - digikey.com/en/maker
DigiKey’s Blog – TheCircuit digikey.com/en/blog
Connect with DigiKey on Facebook facebook.com/digikey.electronics
And follow us on X https://x.com/digikey
Analog Devices ADEMA127 Evaluation Board - Unboxing | DigiKeyRepairable DX07 Series USB-C Receptacles from JAE PIO | DigiKeyNavigate Within an IDE Using Hot Keys #Programming #Microcontroller #STM32IDEES-600 Current Sensor from Ohmite PIO | DigiKeyXBee for Wi-SUN Modules from Digi PIO | DigiKeyLeveraging Development Boards and Modules to Achieve Multimodal Perception AI | DigiKey x DFRobotBES Series Battery Safety Electrolyte Sensor from Honeywell PIO | DigiKeyInfineon PSOC Edge E84 HMI Kit - Unboxing | DigiKeyFiberglass/Polyester Enclosures from Phoenix Mecano PIO | DigiKeyMicrochip EV65U86A CAN - LIN SBC Dev Board - Unboxing | DigiKeyToshiba TDS5B212MX and TDS5C212MX MuxDe-mux – PTM | DigiKeyEdge Card Connectors from Samtec PIO | DigiKey
DigiKey Product Discovery |

Analog Devices ADEMA127 Evaluation Board - Unboxing | DigiKey

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER