Amplifier Check-out Using Lissajous Figures @OldSchoolElectronics
Amplifier Check-out Using Lissajous Figures  @OldSchoolElectronics
Uploaded May 2018 | Updated November 2026, 3 hours ago
I connected the output of the audio generator to the input of one of the amplifier channels. One channel is tested at a time. The amplifier is connected to load resistors, which in this case were 8-ohm resistors. The scope was put into X-Y mode. I connected the vertical (Y) input of the scope across the load resistor. The hot side of the audio generator was connected to the horizontal (X) input. The equipment was allowed to warm up for a few minutes. The waveform from the generator was a 1000 Hz sine wave at first.
The vertical controls were set so a 45-degree line was shown. The generator output needed to bring the amplifier to full rated output (in this case 30 watts per channel continuous into 8 ohms) was determined. I connected an AC voltmeter across the load resistor. I then multiplied the rated wattage by the rating of the load resistor; that is PxR or 30X8. This gave 240. Then I took the square root of this figure which came out to be about 15.49 or 15.5 Volts (RMS). I turned the volume control all the way up and then slowly increased the output of the generator until the voltmeter measured 15.5 volts. I then knew if the volume control was turned all the way up and the generator output was turned up until I reached 15.5 volts, that this was the rated power output. I then left the generator output where it was, but turned down the volume. Once I reconnected the scope probe I across the load resistor I slowly turned the volume up to maximum. i then proceeded to test the amplifier at different frequencies.
Amplifier Check-out Using Lissajous FiguresMarantz 2215B Power Supply Voltage CheckBoombox Function Switch Cleaning And PolishingChecking Record Player (turntable) Cartridge OutputJVC RC-727 Bias Frequency And Current AdjustmentThe Oscilloscope Beam Finder Switch (beginners video)Hitachi HA-270 Stereo Amplifier   Bias and BulbsLeader LTC-905 Curve TracerLeader LP-11 In-Circuit Probe For Leader LTC-905 Curve TracerMarantz 2215B Stereo Receiver Lights PART 1Quick Test Of Receiver With Keuwlsoft Function Generator AppSharp GF-9595 Belts and Pinch Roller Replacement
Old School |

Amplifier Check-out Using Lissajous Figures

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER