Hitachi HA-270 Stereo Amplifier   Bias and Bulbs @OldSchoolElectronics
Hitachi HA-270 Stereo Amplifier   Bias and Bulbs  @OldSchoolElectronics
Uploaded April 2017 | Updated November 2026, 3 hours ago
Unit had unknown problems.

Unit was slowly brought up to line voltage with variable-isolation transformer. Next, the unit was checked for DC-offset (voltage) at the speaker terminals since this is a direct-coupled amp. Amp is dual-power supply (positive and negative) and push-pull direct coupled, meaning there is no capacitor between the output transistors and the speaker(s).

Bias was adjusted statically (meaning without an input signal) per service manual instructions. Unit was allowed to warm up for a few minutes first. Adjustment is supposed to be 8mV, plus or minus 4mV, meaning anywhere from 4mV to 12mV.

Both VU-meter bulbs were replaced. 12V axial bulbs were too expensive. I ended up putting in 12V, 50 mA, bulbs. VU-meter case is held together by tape, which must be carefully removed or cut at the seams. I used the old tape but also used some new clear tape when I put the cases back together.
Hitachi HA-270 Stereo Amplifier   Bias and BulbsLeader LTC-905 Curve TracerLeader LP-11 In-Circuit Probe For Leader LTC-905 Curve TracerMarantz 2215B Stereo Receiver Lights PART 1Quick Test Of Receiver With Keuwlsoft Function Generator AppSharp GF-9595 Belts and Pinch Roller ReplacementFront Panel Marantz 2215B (threaded insert removal)Sharp GF- 9191 MotorSanyo M4500 Stereo Indicator Light ProbllemMarantz 2215B Stereo Receiver Phono AmpRealistic STA-47 monitor switch problemMeasure AM Modulation Percentage With An Oscilloscope
Old School |

Hitachi HA-270 Stereo Amplifier -- Bias and Bulbs

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER