Uploaded February 2025 | Updated September 2026, 16 hours ago

---

Let’s take a close look at why you might want to upgrade your laser’s air assist to a compressor driven system.

Increasing the air flow makes your cuts more efficient leaving you with a cleaner top surface saving you time in your finish work. You also have the ability to control the air flow and reduce down to a trickle of air when engraving so that you are not pushing soot into your fresh engraving.

To make your own DIY kit you can check out this video:
youtu.be/y08B1v8-q-c

For a kit that has high and low flow built in here is a site to check out:
libertycontrols.myshopify.com/collections/all

I also have a section in my Amazon shop that has all the air assist part listed:
Amazon.com/shop/beardedbuildsco

OneLaser Machines
1laser.com/laserguys
Code - LASERGUYS