Adding Brass Bowties to Walnut Serving Board @ToolsToday
Adding Brass Bowties to Walnut Serving Board  @ToolsToday
Uploaded February 2026 | Updated November 2026, 3 days ago
Adding some brass bowties to a serving board. I started out with the Amana Tool Item No. 51408-Z 3/16" diameter ZrN coated spiral 'O' flute bit from Toolstoday, toolstoday.com/v-14615-51408-z.html , using the Axiom Precision AR8 CNC machine toolstoday.com/v-14604-axiom-prov5-series.html
- - - - - - -
RPM: 18,000
Feed Rate: 55ipm
Plunge Rate: 15ipm
Depth Per Pass: .04"
- - - - - - -
A pocket was cut using the item no. 46200-K 1/8" diameter Spektra ™ coated downcut bit, toolstoday.com/v-13777-46200-k.html , and the bowties fit perfectly with a -.3mm pocket allowance in the Vectric software, toolstoday.com/cnc-machines-accessories/cnc-software.html , to give a little extra room for the epoxy and any expanding wood grain from it.
- - - - - - -
RPM: 18,000
Feed Rate: 60ipm
Plunge Rate: 30ipm
Depth Per Pass: .1"
- - - - - - -
The downcut bit worked great on the serving board leaving a perfectly clean top surface without any cleanup required. The bowties were installed with some Total Boat epoxy. After it was dry the piece was sanded down with 220 grit. The piece was then finished off with Walrus Cutting Boar Oil for a durable matte finish! toolstoday.com/walrus-oil-cutting-boardoil.html #short #shorts
Adding Brass Bowties to Walnut Serving BoardEasy Lumber StorageSet Depth and it Does the RestUnboxing and Setting Up 5hp Shaper   Powermatic PM2700Reinforcing Heavy Duty Wheel Dollies with ¼ Inch SteelFlush Trimming Thick OakBuilding the Ultimate Woodworking WorkbenchEasy to Make Juice Groove Jig for Cutting BoardsCutting the First Steel Plate for Wheel Dolly ReinforcementMaking a Laser Cut Template for a CNC Cut PartPortable Logo Engraving ToolRouting Perfect Fitting Stile and Rail Joint #woodworking
ToolsToday |

Adding Brass Bowties to Walnut Serving Board

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER