97% Efficient DC to DC Buck Converter Circuit [3A Adjustable] @MyVanitar
97% Efficient DC to DC Buck Converter Circuit [3A Adjustable]  @MyVanitar
Uploaded October 2019 | Updated November 2026, 4 days ago
Buck Converter Circuit [DC to DC, Adjustable, 97% Efficient, 3A]

A tiny DC to DC buck converter (Step down) board is useful for many applications, especially if it could deliver currents up to 3A (2A continuously without heatsink). In this article, we will learn to build a small, efficient, and cheap converter circuit using MP2315.

=============================================

Article Source: pcbway.com/blog/technology/DC_to_DC_Buck_Converter_Adjustable__97__Efficient__3A.html

=============================================

Support me on Patreon: patreon.com/myvanitar

=============================================

Check other videos: bit.ly/2N9OlPa

=============================================


The main component is the MP2315 step-down buck converter. According to the MP2315 [1] datasheet: “The MP2315 is a high frequency synchronous rectified step-down switch-mode converter with built-in internal power MOSFETs. It offers a very compact solution to achieve 3A continuous output current over a wide input supply range with excellent load and line regulation. The MP2315 has synchronous mode operation for higher efficiency over output current load range. Current mode operation provides a fast transient response and eases loop stabilization. Full protection features include OCP and thermal shut down.” Low RDS(on) allows this chip to handle high currents.
C1 and C2 are used to reduce input voltage noises. R2, R4, and R5 build a feedback path to the chip. R2 is a 200K multiturn potentiometer to adjust the output voltage. L1 and C4 are the essential buck converter elements. L2, C5, and C7 make an additional output LC filter that I added to reduce the noise and ripple. The cut-off frequency of this filter is around 1KHz. R6 limits the current flow to the EN pin. The R1 value has been set according to the datasheet. R3 and C3 are related to the bootstrap circuit and determined according to the datasheet.
Figure 2 shows the efficiency vs output current plot. The highest efficiency for almost all input voltages has been achieved at around 1A.


#DC_to_DC_Buck_Converter
#DC_to_DC_Step_Down
97% Efficient DC to DC Buck Converter Circuit [3A Adjustable]LM317/LM338 30V-3A Efficient Adjustable Power Supply using LM2576 Switching Pre-Regulator30V-4A Adjustable Power Supply Circuit [CV, CC]🔶 High Precision Digital AC Energy Meter Circuit [Voltage, Current, Power, KWh]Altium Designer 5 Useful Design/Routing TipsGround Plane Under a Common-Mode Choke: Good or Bad? (VNA Results)How to Easily Set up the FFT Function in the Siglent SDS1104X-E OscilloscopeCheap USB to UART (RS232/Serial) Converter Using Microchip MCP2200DIY Safe USB Passkey12V Flyback DC-DC Converter Circuit Using UCC28881DIY Universal AC-DC Power Supply Circuit | 12V 3A (36W) | Low Noise Design433MHz 4-Channels Wireless Switcher Circuit
MyVanitar |

97% Efficient DC to DC Buck Converter Circuit [3A Adjustable]

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER