#411: Tool Tip: Not all Phillips screws are created equal - JIS vs. Phillips screws and drivers @w2aew
#411: Tool Tip: Not all Phillips screws are created equal - JIS vs. Phillips screws and drivers  @w2aew
Uploaded June 2026 | Updated November 2026, 4 days ago
This short video demonstrates the slight differences of the "phillips" screws found on Japanese manufactured electronics and products. The very subtle differences in geometry cause ordinary Phillips screwdrivers and bit to not fit very well which can lead to damaging the screws. These screws are made to the Japanese JIS standard. Screwdrivers made to the JIS standard are available and should be part of your toolbox if you work on or repair any Japanese manufactured electronics and other devices & products.
#411: Tool Tip: Not all Phillips screws are created equal - JIS vs. Phillips screws and drivers#247: Circuit Fun: 5 Transistor ESR Meter circuit by EEVBlog user Jay_Diddy_B#346: Basics of Capacitor Leakage / using the Antique Wireless Association DC Leakage Tester#279: Ham Radio: WSPRlite review plus DXplorer and view of 4-FSK transmission#236: Using a Current Shunt with a Panel Meter / Ammeter scale change#331: Ham Tips: Operating Split on HF - info, tips & tricks for operating split or Duplex on HF#287: How to use the Delayed B-Sweep Timebase on Tektronix 2465 2445 2455 2467 Oscilloscopes#307: Back to Basics: Potentiometers - Controls and trimmers / trimpots - WARNING!#364: Ham Radio quickie: Single Sideband (SSB) receive audio quality on the Penntek TR-45L#298: Electronic Project / Experimenters Kits - Then and Now - Science Fair and Elegoo#354: Help! Do you have a good suggestion for bench lighting that doesnt have THIS problem?#300: Ham Basics: Sending Morse Code / CW - straight key, paddles and iambic keying
w2aew |

#411: Tool Tip: Not all Phillips screws are created equal - JIS vs. Phillips screws and drivers

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER