#300: Ham Basics: Sending Morse Code / CW - straight key, paddles and iambic keying @w2aew
#300: Ham Basics: Sending Morse Code / CW - straight key, paddles and iambic keying  @w2aew
Uploaded May 2019 | Updated November 2026, 7 minutes ago
This video talks about the basic timing of CW / Morse code elements (dits and dahs), and how to send them using a few device - such as a traditional straight key, as well as using a dual-lever paddle with an electronic keyer. Iambic keying with a paddles is also described and demonstrated.

Notes from the video: qsl.net/w2aew/youtube/Morse_Code_Timing.pdf
#300: Ham Basics: Sending Morse Code / CW - straight key, paddles and iambic keying#337: Use a NanoVNA to measure input impedance and gain of a small-signal RF amplifier#344: ARRL 49:1 End Fed Halfwave UNUN transformer kit from HFKits - Build and quick bench test#356: Back to Basics: the Emitter Follower, or Common-Collector Amplifier#246: How to operate / tune the Yaesu FRG-7 Frog-7 Receiver#335: My Saturday: Early AM hamfest and some interesting cars#404: The VFET is a JFET that thinks it is a Triode vacuum tube - aka Static Induction Transistor#257: Power Supply Decoupling &  Filtering: why we use multiple caps in different locations#376: Ham Radio: Build, Tune and Test a QRP End Fed UNUN kit from KM4CFT#299: How to build an Open - Short - Load (OSL) Calibration kit for HF Antenna Analyzer#227: Vintage Tech: Fluke 881A Differential Voltmeter Introduction#370: FX-4CR Transceiver PCB replacement procedure
w2aew |

#300: Ham Basics: Sending Morse Code / CW - straight key, paddles and iambic keying

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER