#246: How to operate / tune the Yaesu FRG-7 Frog-7 Receiver @w2aew
#246: How to operate / tune the Yaesu FRG-7 Frog-7 Receiver  @w2aew
Uploaded October 2016 | Updated November 2026, 8 hours ago
This video shows how to tune the Yaesu FRG-7 Communications Receiver. It operates a little differently than a conventional receiver due to the Wadley Loop architecture being used. It shows the details on how to use the preselector and megahertz tuning controls. For more information on the Wadley Loop circuit, please see my previous video:
youtube.com/watch?v=JvS9tBWAc1s
#246: How to operate / tune the Yaesu FRG-7 Frog-7 Receiver#335: My Saturday: Early AM hamfest and some interesting cars#404: The VFET is a JFET that thinks it is a Triode vacuum tube - aka Static Induction Transistor#257: Power Supply Decoupling &  Filtering: why we use multiple caps in different locations#376: Ham Radio: Build, Tune and Test a QRP End Fed UNUN kit from KM4CFT#299: How to build an Open - Short - Load (OSL) Calibration kit for HF Antenna Analyzer#227: Vintage Tech: Fluke 881A Differential Voltmeter Introduction#370: FX-4CR Transceiver PCB replacement procedure#316: Use NanoVNA to measure coax length - BONUS Transmission Lines and Smith Charts,  SWR and more#394: Oscilloscope Best Practices - some of the most common issues and tips#407: Installation of Yaesu optional 500Hz Collins Mechanical Filter in the FT-857D#252: Acquisition & Analysis control in a Real-Time Spectrum Analyzer RSA | RSA306B
w2aew |

#246: How to operate / tune the Yaesu FRG-7 Frog-7 Receiver

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER