3D Printer Review: FLASHFORGE CREATOR X - Ec-Projects @EcProjects
3D Printer Review: FLASHFORGE CREATOR X - Ec-Projects @EcProjects
Uploaded July 2014 | Updated September 2026, 1 week ago
In this video I review my FLASHFORGE Creator X 3D printer. We will go through the advantages over the previous model and we will make a few prints as well.. !

If you like this video, make sure to subscribe to my new "Off topic" channel EcTechTime where stuff like this will go in the future !

youtube.com/EcTechTime

------------------------------------------------------------------------------

Both prints are downloaded from thingiverse.com
thingiverse.com/thing:295317
thingiverse.com/thing:263591
3D Printer Review: FLASHFORGE CREATOR X - Ec-ProjectsArduino Alarm System Build (Part 1) - Ec-ProjectsHow to drive an LED (Part 1) - Ec-ProjectsStepper Motor Torque Test (Damaged Form Being Taken Apart?) - Ec-Projects100W LED Analysis: Dodgy segments! Or are they ? - Ec-ProjectsSignal reflections and Transmission lines - Ec-ProjectsFPGAs and VHDL- Part 2: Making a Counter - Ec-ProjectsQuick Tip: Charge a Salvaged Cell Phone Battery on the Bench - Ec-ProjectsTesting a solar panel - Ec-ProjectsDIY 3D-Printer Build (From Scratch) - Part 8: Installing Extruder and Filament Holder - Ec-ProjectsSound Wave Interference (And how speakes can play many tones at the same time) - Ec-ProjectsWhat is an Operational Amplifier (Op-amp) - Ec-Projects
EcProjects |

3D Printer Review: FLASHFORGE CREATOR X - Ec-Projects

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER