DIY 3D-Printer Build (From Scratch) - Part 8: Installing Extruder and Filament Holder - Ec-Projects @EcProjects
DIY 3D-Printer Build (From Scratch) - Part 8: Installing Extruder and Filament Holder - Ec-Projects @EcProjects
Uploaded September 2015 | Updated September 2026, 1 week ago
In this video I install the extruder, filament drive and make a filament spool holder. We test the printer, but only to realize the "old" extruder / hot-end wasn't working. After installing the new one, which I made in the previous video, it is working great!
Filament drive part (my brother's video): youtu.be/k0EOY19YPVc

¤¤¤¤ -- SUPPORT Ec-Projects -- ¤¤¤¤

By using my Amazon.com affiliate link (No extra cost for you!) - amzn.to/1kNT3RM
By becoming a Patreon for as little as $1 per month - patreon.com/EcProjects
DIY 3D-Printer Build (From Scratch) - Part 8: Installing Extruder and Filament Holder - Ec-ProjectsSound Wave Interference (And how speakes can play many tones at the same time) - Ec-ProjectsWhat is an Operational Amplifier (Op-amp) - Ec-ProjectsDIY Transistor Tester (Part 2) - Ec-ProjectsWhats Inside a Hard Drive ? (Teardown / Taken apart) - Ec-ProjectsConstant Current LED Driver - Switch Mode (Part 3) - Ec-ProjectsMotorola Cell Phone USB Connector Replacement / Repair - Ec-ProjectsTour Of The Shop / Lab - 2014 - Ec-ProjectsConstant Current Supply for LEDs and more - Linear (Part 2) - Ec-ProjectsDIY Transistor Tester (Part 1) - Ec-ProjectsBuilding the Worlds Brightest LED Flashlight (1800w): Part 4 - Ec-Projects40W Chinese Laser Cutter: Review, Setup, Use - Ec-Projects
EcProjects |

DIY 3D-Printer Build (From Scratch) - Part 8: Installing Extruder and Filament Holder - Ec-Projects

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER