Uploaded March 2019 | Updated September 2026, 1 week ago

---

"Quick" introduction to signal reflections! A few things I forgot to mention, that I noticed when I edited the video. This is a big topic for PCB design as well! Especially at higher frequencies. And the same techniques apply. For systems where you use the same wires for RX/TX you would put the parallel termination in both ends of the cable (RS485, CAN, etc ).

¤¤¤¤ -- SUPPORT Ec-Projects -- ¤¤¤¤

By using my Amazon affiliate links (No extra cost for you!)
Amazon US - amzn.to/1kNT3RM
Amazon UK - amzn.to/1OnZ2aX
Amazon DE - amzn.to/1Vt6zqg

By becoming a Patreon for as little as $1 per month
Patreon - patreon.com/EcProjects

¤¤¤¤ ----------------------------------------- ¤¤¤¤