Uploaded December 2025 | Updated November 2026, 3 hours ago
This is a 'classic' 1987 2hp Honda outboard : BF2AH
At nearly 40y old it's given great service but was due a refresh. I was going to refurbish the carb but it turned out that a complete replacement carb was only a little more than an official Honda gasket set. I think the new carb I bought must be for the later 2.3hp model. Very similar but slight differences in the fuel valve, which necessitated a couple of minor adjustments. All working now though.
NOTE: I used GL5 gear oil in the video. I've since learnt that this can corrode the bronze bushes, so I've since swapped it for GL4 which is safe with copper alloys.
00:52 Carb removal
01:48 Gearbox & water pump impeller
05:50 Gearbox seal replacement
11:05 Replacement carb - differences from original carb
12:45 Gearbox reassembly
15:21 Carb reassembly - fuel valve issues
18:03 Test run (reversed fuel valve)
This is a 'classic' 1987 2hp Honda outboard : BF2AH
At nearly 40y old it's given great service but was due a refresh. I was going to refurbish the carb but it turned out that a complete replacement carb was only a little more than an official Honda gasket set. I think the new carb I bought must be for the later 2.3hp model. Very similar but slight differences in the fuel valve, which necessitated a couple of minor adjustments. All working now though.
NOTE: I used GL5 gear oil in the video. I've since learnt that this can corrode the bronze bushes, so I've since swapped it for GL4 which is safe with copper alloys.
00:52 Carb removal
01:48 Gearbox & water pump impeller
05:50 Gearbox seal replacement
11:05 Replacement carb - differences from original carb
12:45 Gearbox reassembly
15:21 Carb reassembly - fuel valve issues
18:03 Test run (reversed fuel valve)










