Uploaded November 2019 | Updated September 2026, 2 weeks ago
Part 2 of my rant about this outer CV joint that does not come apart. NOT a DIY video but if you are planning to do this job this may interest you.
Link to Part 1: youtu.be/b2otrne6PI8
(Post job update: I wiped as much of the old grease out as I could and it seemed reasonably clean. Then I used a grease gun injector needle to squirt grease past the ball bearings into the back side of the joint. Be careful not to push the needle in too far, just in case the needle breaks off or comes apart and you need to retrieve it. Mine came apart and I was lucky to be able to get it out of there with a pair of tweezers.)
Part 2 of my rant about this outer CV joint that does not come apart. NOT a DIY video but if you are planning to do this job this may interest you.
Link to Part 1: youtu.be/b2otrne6PI8
(Post job update: I wiped as much of the old grease out as I could and it seemed reasonably clean. Then I used a grease gun injector needle to squirt grease past the ball bearings into the back side of the joint. Be careful not to push the needle in too far, just in case the needle breaks off or comes apart and you need to retrieve it. Mine came apart and I was lucky to be able to get it out of there with a pair of tweezers.)
