What happens if youre too slow to wire off? #ceramics @OldForgeCreations
What happens if youre too slow to wire off? #ceramics  @OldForgeCreations
Uploaded November 2025 | Updated November 2026, 53 minutes ago
The biggest downside to leaving pieces on their batts overnight is the risk of getting the timing wrong. This was only slightly too firm, but it can be a bigger problem is left a bit longer. Eventually, the best option is to give up on wiring off and just leave the piece to fall off the batt.

Wiring off a piece that doesn't want to come off will put a lot of lateral stress into the piece and leave you with a very uneven base (before trimming, that is), both of which can contribute to a piece warping when fired.

Support the creation of more videos on Patreon: patreon.com/oldforgecreations

For examples of my work that's been glazed, check out my Instagram:
instagram.com/oldforgecreations

Buy my work, or read more on my blog:
oldforgecreations.co.uk/shop

Link to tools: oldforgecreations.co.uk/recommended-tools
What happens if youre too slow to wire off? #ceramicsThere are many different mixer designs, but does shape matter for mixing glazes? #ceramicsNow you can dip glazes with maximum efficiency too! #3dprinting #ceramicsPreparing For Plaster - 3D Printing for a Slipcast OrnamentWhy I share all my glaze recipes #ceramicsSmall adjustment to improve two things at once #ceramics #slipcasting #3dprintingIm still not certain at what point a sniff becomes a sniftFirst thoughts of the new Bistro Porcelain #ceramicsMaking multicoloured coasters with leftover slip  #potteryWhy I use a funnel in my 3 part moulds #slipcasting #3dprintingMake your own Flux glaze! #ceramics #glazePlanning to make your own glazes in 2026? Heres where to start!
Old Forge Creations |

What happens if you're too slow to wire off? #ceramics

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER