Uploaded June 2026 | Updated November 2026, 41 minutes ago
Using a 3D printed funnel as a slip reservior on the 3-part Ornament and Bud Vase moulds means there isn't any need to trim the excess slip off.
The reason it went so badly when trimming the little tumbler is that I'm trying a new slip recipe that's essentially a porcelain with only Grolleg clay in the body, and that makes it incredibly short when trimming. The vase is cast in the same clay and came out perfectly because there's no trimming required!
I will go back and adjust the recipe though 😂
---
Support the creation of more videos on Patreon: patreon.com/oldforgecreations
For examples of my work that's been glazed, check out my Instagram:
instagram.com/oldforgecreations
Buy my work, or read more on my blog:
oldforgecreations.co.uk/shop
Link to tools: oldforgecreations.co.uk/recommended-tools
Using a 3D printed funnel as a slip reservior on the 3-part Ornament and Bud Vase moulds means there isn't any need to trim the excess slip off.
The reason it went so badly when trimming the little tumbler is that I'm trying a new slip recipe that's essentially a porcelain with only Grolleg clay in the body, and that makes it incredibly short when trimming. The vase is cast in the same clay and came out perfectly because there's no trimming required!
I will go back and adjust the recipe though 😂
---
Support the creation of more videos on Patreon: patreon.com/oldforgecreations
For examples of my work that's been glazed, check out my Instagram:
instagram.com/oldforgecreations
Buy my work, or read more on my blog:
oldforgecreations.co.uk/shop
Link to tools: oldforgecreations.co.uk/recommended-tools

