Use a transistor as a switch (#22 AC and Switching Circuits) @adanner
Use a transistor as a switch (#22 AC and Switching Circuits)  @adanner
Uploaded February 2022 | Updated November 2026, 2 days ago
How to switch a motor on and off using a low voltage signal. Here we switch a 50V motor on and off using a 5V output pin from an Arduino. You can use a transistor to switch on and off large amounts of current using only small signals. I show conceptually how to use NPN and PNP bipolar transistors and also introduce n-channel and p-channel MOSFETs as switches.

This video series introduces basic AC circuit design and analysis, how transformers and switches like relays and transistors are used, and finally in later videos a power supply is designed from basic principles.

Aaron Danner is a professor in the Department of Electrical and Computer Engineering at the National University of Singapore.
https://www.ece.nus.edu.sg/stfpage/eleadj

Video filmed and edited by Cheryl Lim.
@randomcheryl
Use a transistor as a switch (#22 AC and Switching Circuits)Non-sinusoidal AC circuits - Triangular wave (#14 AC and Switching Circuits)Node Voltage Analysis (Circuits for Beginners #15)Bandpass active filters with Sallen-Key circuits (5 - Active Filters)How to install a GFCI outlet (7 - Electricity Distribution)What happens when you wire an electrolytic capacitor backwards? (Circuits for Beginners #24)100% Solar Quadcopter Flies Over 4 HoursNon-sinusoidal AC circuits - Square wave (#13 AC and Switching Circuits)Build a Power Supply from Scratch (#20 AC and Switching Circuits)How much worse does a motor perform with a gearbox? (Motors #8)Our 100% solar quadcopter can fly without an onboard batteryInput Bias Current in Op-Amps (Amplifiers #9)
Aaron Danner |

Use a transistor as a switch (#22 AC and Switching Circuits)

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER