Build a Power Supply from Scratch (#20 AC and Switching Circuits) @adanner
Build a Power Supply from Scratch (#20 AC and Switching Circuits)  @adanner
Uploaded February 2022 | Updated November 2026, 5 hours ago
Let's design and build a DC power supply with a transformer, diodes, and a filter capacitor. We will use a full bridge rectifier and estimate the value of the filter capacitor. This video discusses all the major aspects of the design. The power supply is a simple AC-DC converter and is unregulated (that is, the voltage is unclamped at the output).

This video series introduces basic AC circuit design and analysis, how transformers and switches like relays and transistors are used, and finally in later videos a power supply is designed from basic principles.

Aaron Danner is a professor in the Department of Electrical and Computer Engineering at the National University of Singapore.
https://www.ece.nus.edu.sg/stfpage/eleadj

Video filmed and edited by Cheryl Lim.
@randomcheryl
Build a Power Supply from Scratch (#20 AC and Switching Circuits)How much worse does a motor perform with a gearbox? (Motors #8)Our 100% solar quadcopter can fly without an onboard batteryInput Bias Current in Op-Amps (Amplifiers #9)Find the Equivalent Impedance (#7 AC and Switching Circuits)1-pole low pass passive filter examples (6 - Passive Filters)Vacuum Tubes 1: The FilamentSources in Series and Parallel (Circuits for Beginners #10)How to use a relay as a switch (#23 AC and Switching Circuits)Linear Circuit Elements (Circuits for Beginners #17)Darlington Configuration (22-Transistors)Lets build a VERY SIMPLE radio transmitter (1-Analog Electronics)
Aaron Danner |

Build a Power Supply from Scratch (#20 AC and Switching Circuits)

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER