Unboxing and Using the FEIN VersaMAG 160 L Magnetic Vise @ToolsToday
Unboxing and Using the FEIN VersaMAG 160 L Magnetic Vise  @ToolsToday
Uploaded September 2026 | Updated November 2026, 2 hours ago
After unboxing the FEIN VersaMAG Vise 160 L, I immediately mounted it to a 2-foot by 4-foot sheet of 1/4-inch steel on the workbench. With the magnet fully engaged, picking up the vise also lifted the heavy steel plate along with it. I then moved it to the table of the JET JDP-20S Smart Drill Press, where partially engaging the magnet allowed for fine adjustments before locking the vise into place. Once aligned, the vise could be quickly released and repositioned as the 10 holes were drilled. It was a good demonstration of how the vise can be moved and positioned on different magnetizable surfaces without permanently mounting it in one location. All tools used are available from @toolstoday, check them out on our site!
--
FEIN VersaMAG Vise 160 L Magnetic Vise
toolstoday.com/fein-99100001357-versamag-vise-160-l-magnetic-vise-with-jaw-opening-of-6-1-4-and-width-of-6.html
JET JDP-20S 20" Smart Drill Press
toolstoday.com/jet-jdp-20s-20-smart-drill-press.html
Sjobergs Elite 2000 Workbench Combo with SM04 Cabinet and Elite Accessories Kit
toolstoday.com/sjobergs-sjo-99402k-elite-2000-workbench-combo-with-sm04-cabinet-and-elite-accessories-kit.html
Unboxing and Using the FEIN VersaMAG 160 L Magnetic ViseFlat Pack Connection System for DominoWire Burning and Finishing MalletTrend Router Table Unbox & AssemblyPerfect Roundover Bit for Tight CornersLock Miter Setup Without the GuessworkFlattening a Twisted Board on the CNCSeamless Tongue and Groove Edge BandingFrom Plywood to Pro Cornhole Board | ToolsToday
ToolsToday |

Unboxing and Using the FEIN VersaMAG 160 L Magnetic Vise

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER