Uploaded April 2022 | Updated November 2026, 3 hours ago
A simple 3D-printed clock using two servos to drive the hands, and an Arduino-programmable board that connects to WiFi to get the correct time. Total parts cost about ten dollars in April 2022. DIY MORE ESP8285 Mcu Strong. Two 9-gram servos (Tower Pro or similar). The STL files for 3D printing the parts can be downloaded from ceptimus.co.uk/twoServoClock/stlFiles.zip The sketch (Arduino IDE) for programming the microcontroller can be downloaded from ceptimus.co.uk/twoServoClock/twoServoClock.zip The files and photos are also on Prusa printables here: printables.com/model/173810-two-servo-clock
A simple 3D-printed clock using two servos to drive the hands, and an Arduino-programmable board that connects to WiFi to get the correct time. Total parts cost about ten dollars in April 2022. DIY MORE ESP8285 Mcu Strong. Two 9-gram servos (Tower Pro or similar). The STL files for 3D printing the parts can be downloaded from ceptimus.co.uk/twoServoClock/stlFiles.zip The sketch (Arduino IDE) for programming the microcontroller can be downloaded from ceptimus.co.uk/twoServoClock/twoServoClock.zip The files and photos are also on Prusa printables here: printables.com/model/173810-two-servo-clock










