AtTiny85 MPU6050 gyro. How to program and configure. @ceptimus
AtTiny85 MPU6050 gyro. How to program and configure.  @ceptimus
Uploaded July 2020 | Updated November 2026, 3 hours ago
This long video covers how to set up the Arduino IDE to program and configure the ATtiny85, how to use Zadig to install the correct driver for a USBasp, and how to connect the USBasp and a serial interface to the gyro. It also shows the finished (?) gyro working, and demonstrates the serial debug mode.


Details and Arduino sketch available on the Mode Zero forum. You may need to register but it's free. mode-zero.uk/viewtopic.php?f=42&t=1018&start=10 Sketch is at the bottom of page 2.
AtTiny85 MPU6050 gyro. How to program and configure.Sutton Park Radio Control January 199112864B V2.0 LCD display module Arduino demoReading 18 channels of PWM with an Arduino NanoSBUS to PWM decoder on ArduinoAT89C2051 clock kits.  Firmware and source code for three-button variety.Arduino SBUS decoder with OLED display and CPPM outputVCCC24 My Snake wild competition entryDifferent patterns on the 57-LED hourglass kits, and how to alter the clock speedRadio control (four channel proportional) using two Arduinos with nRF24L01+modules .Lidl Pulser Flight video (ground view and on-board)Slope soaring. Walton-on-the-Naze, Essex.
ceptimus |

AtTiny85 MPU6050 gyro. How to program and configure.

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER