Uploaded July 2019 | Updated November 2026, 14 hours ago
I attended a seminar last spring at the Oregon Woodturning Symposium about casting resin. One of the takeaways I got was that I needed to find a used pressure pot to do resin casting in. When casting resin under high air pressure, the bubbles get squeezed down so small that you can't see them and you get a clear resin cast. I found a pressure pot on Craigslist and picked it up for $25. It needed some work to be converted from a paint pressure pot for paint spraying to one for resin casting. There was a bunch of paint spraying functions with the pot that I did not need so I remove those parts. Then I chased down all the leaks in the pressure pot from the different attachments and also made a new lid seal. It now seems to be working and I did a test with some old resin that turned out a little bit yellow. The bubbles in the cast that I did in the pressure pot are definitely smaller but they did not quite completely disappear. I hope this is because I was using old, somewhat thick resin and with some fresh resin I hope I will get a clear cast.
Donek Drag Knife: cncrouterparts.com/donek-drag-knife-p-264.html
Zac Higgins channel: youtube.com/user/NVWoodwerks
Tools used in this project can be found at frankmakes.com
To see upcoming projects follow me on social media
Patreon
patreon.com/user?u=16151185
Instagram
instagram.com/frank.howarth
Twitter
twitter.com/FrankHowarth
Facebook
facebook.com/FrankMakes
I attended a seminar last spring at the Oregon Woodturning Symposium about casting resin. One of the takeaways I got was that I needed to find a used pressure pot to do resin casting in. When casting resin under high air pressure, the bubbles get squeezed down so small that you can't see them and you get a clear resin cast. I found a pressure pot on Craigslist and picked it up for $25. It needed some work to be converted from a paint pressure pot for paint spraying to one for resin casting. There was a bunch of paint spraying functions with the pot that I did not need so I remove those parts. Then I chased down all the leaks in the pressure pot from the different attachments and also made a new lid seal. It now seems to be working and I did a test with some old resin that turned out a little bit yellow. The bubbles in the cast that I did in the pressure pot are definitely smaller but they did not quite completely disappear. I hope this is because I was using old, somewhat thick resin and with some fresh resin I hope I will get a clear cast.
Donek Drag Knife: cncrouterparts.com/donek-drag-knife-p-264.html
Zac Higgins channel: youtube.com/user/NVWoodwerks
Tools used in this project can be found at frankmakes.com
To see upcoming projects follow me on social media
Patreon
patreon.com/user?u=16151185
instagram.com/frank.howarth
twitter.com/FrankHowarth
facebook.com/FrankMakes










