Uploaded March 2026 | Updated September 2026, 8 hours ago

---

While developing SteinWipe Pro's print profile for MakerWorld, I discovered my flawless profile which prints perfectly from my computer did not print so well once uploaded to MakerWorld. But why? Here I show the setting that is causing these little zits to form and its because of retraction! Bambu's stock retraction lengths are too long and introduce air into the melt zone!

Support this project on Patreon here:
patreon.com/collection/1996041

#bambulab
#3dprintinglife
#3dprinted