Uploaded September 2024 | Updated September 2026, 2 weeks ago
In a couple previous #shorts I found out that PLA prints warp in a hot car, and then tried to use the same hot car to fix the issue. It helped, but many of the PLA magnets I made still were warped badly.
So for a last try, I used boiling water and a cookie tray to flatten them out. This actually worked great and I was able to recover the prints so I could sell them!
To answer the safety questions: 1. I don't use that sauce pan anyway, yes I'll wash it before I put it away. Same with the cookie tray. 2. The dish cloth doesn't get hot enough to burn.
The prints are mostly Colorfabb Economy PLA and GlowFill. The magnets I sell at #autism fairs.
In a couple previous #shorts I found out that PLA prints warp in a hot car, and then tried to use the same hot car to fix the issue. It helped, but many of the PLA magnets I made still were warped badly.
So for a last try, I used boiling water and a cookie tray to flatten them out. This actually worked great and I was able to recover the prints so I could sell them!
To answer the safety questions: 1. I don't use that sauce pan anyway, yes I'll wash it before I put it away. Same with the cookie tray. 2. The dish cloth doesn't get hot enough to burn.
The prints are mostly Colorfabb Economy PLA and GlowFill. The magnets I sell at #autism fairs.
