My Tech Fun | The toothpick positioning method (Laser engraving with LightBurn and LaserGRBL) @MyTechFun | Uploaded July 2023 | Updated October 2024, 9 hours ago.
With some laser modules, it is hard to see the position of the laser spot during the framing (or boundary check). With this method, we can use the toothpick for this, which is outside, so the framing is much easier, and it is independent from the surface color.
The method can be used with LightBurn and LaserGRBL.
Contents:
0:00 Introduction to problem
0:38 Installing the toothpick
1:41 LaserGRBL
2:24 LightBurn
3:04 Conclusions
#laserengraver #laserengraving
With some laser modules, it is hard to see the position of the laser spot during the framing (or boundary check). With this method, we can use the toothpick for this, which is outside, so the framing is much easier, and it is independent from the surface color.
The method can be used with LightBurn and LaserGRBL.
Contents:
0:00 Introduction to problem
0:38 Installing the toothpick
1:41 LaserGRBL
2:24 LightBurn
3:04 Conclusions
#laserengraver #laserengraving