Uploaded October 2018 | Updated September 2026, 2 weeks ago

---

Here is a large Halloween 3D model printed in PLA Plus on the 310 Wham Bam Flexible Build System.

You can see how effectively the PEX build surface held the print down, even tall thin supports stuck well. You can also watch as it easily the print is removed with a minimum of flexing of the build plate, 30 seconds and we are back to printing! This was a part with a huge flat surface area, imagine chiseling that off a conventional print?
Get your Flexible Build System at whambamsystems.com

Do not take our word for it, check our reviews by our testers:
Nery's review: youtu.be/pSXgYwEcO6s
BV3D's initial unboxing, install and review: youtu.be/zNv6f18Cm0M
BV3D's review after 3 weeks of nearly daily use: youtu.be/0uG3NfgTkS0


Cr-10 enclosure was created by our founder Peter, check out the design on Thingiverse: thingiverse.com/thing:2663180