Taking Apart My New Stirling Engine #5 to Fix the Displacer (it melted) @makerj101
Taking Apart My New Stirling Engine #5 to Fix the Displacer (it melted)  @makerj101
Uploaded September 2013 | Updated November 2026, 4 days ago
I have run it for a total of 3-4 hours and the displacer has failed! Not because of wear but because the piece of aluminium that holds the steel wool displacer on the push rod totally melted! It melted because I was running it with the displacer cylinder glowing. I am going to need to make a new bottom part for my displacer. This time I'll probably make it out of steel or I'll make it out of aluminium again. If I make it out of aluminium I will have to be careful not to get it as hot and let this displacer stop at the bottom of the stroke for very long.

Thank you for watching!
Taking Apart My New Stirling Engine #5 to Fix the Displacer (it melted)Free Energy Magnetic Resonator WorksTaking Apart My Stirling Engine #4 With Failed DisplacerHow To Identifying Aluminium, Zinc, and Other Metals For CastingUnboxing and First Impression of the Power + 8000 Air Rework Station 2 in 1 Soldering StationUnmodified AC Induction Motor Working as a Generator ExperimentExploring Old Abandoned Crane part 2 - Inside the Crane, Huge Winches and MotorHow to Make an Awesome Ring Out of a QuarterBuilding the Displacer Cylinder For My New Stirling Engine #5 - Part 2 of 2Running the Steam Engine at Higher Pressure with New Pressure Relief ValveUranium Glass - Woods Exploration Followup Using Geiger Counter and Ultraviolet LightLife and Shop Update. Sorry for no videos for a while, took a vacation. Vids coming soon!
Makerj101 |

Taking Apart My New Stirling Engine #5 to Fix the Displacer (it melted)

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER