Uploaded June 2013 | Updated November 2026, 9 hours ago
It failed because I over heated it which made the air inside the sealed displacer expand and pop the bottom of the can out. I could have put a tiny hole in the displacer but I think that would make the sides of the soda can kink in and out when the pressure changes because the air would not be able to go through fast enough. If the air could go through it would lose a lot of power. My new design will be easy to take apart so I can test different displacer designs. It will use the same wood frame with small modifications and same flywheel.
It failed because I over heated it which made the air inside the sealed displacer expand and pop the bottom of the can out. I could have put a tiny hole in the displacer but I think that would make the sides of the soda can kink in and out when the pressure changes because the air would not be able to go through fast enough. If the air could go through it would lose a lot of power. My new design will be easy to take apart so I can test different displacer designs. It will use the same wood frame with small modifications and same flywheel.










