Vez3D | #SpeedBoatRace Benchy 6:50 (second attempt) @Vez3D | Uploaded April 2021 | Updated October 2024, 20 hours ago.
#SpeedBoatRace : youtube.com/hashtag/speedboatrace
Nitram's crazy delta: youtube.com/watch?v=J8p46wDM5KM
Annex Engineering 4Motors CoreXY: youtube.com/watch?v=tHI9v4wh4aA
Hevort: hevort.com
please join the speedboat race on our discord: discord.gg/MzTR3zE
-------------------
The rules are as follows;
you must use PLA, PLA+, PETG, ASA, ABS, or ABS+
you cannot use filled, metallic, or silk filaments (these filaments typically hide defects)
the print must finish
the maximum nozzle or line width size is 0.5mm
the maximum layer height is 0.25mm
You may combine infill every other layer
You must record the whole print
you must use 3 top and bottom layers
you must use 2 walls and 10% infill
The finished print must be dimensionally accurate (within reason) bonus points if it looks good!
The machine must be powered by stepper motors
There must be a timer/clock shown in the video to verify its real time.(a phone is fine or you can show the time before and after the print)
You must share the profile !
You must post the video to Youtube and a link to said video in #speedboat_entries or the annex engineering subreddit
This is all in good fun and faith so just have fun!
#SpeedBoatRace : youtube.com/hashtag/speedboatrace
Nitram's crazy delta: youtube.com/watch?v=J8p46wDM5KM
Annex Engineering 4Motors CoreXY: youtube.com/watch?v=tHI9v4wh4aA
Hevort: hevort.com
please join the speedboat race on our discord: discord.gg/MzTR3zE
-------------------
The rules are as follows;
you must use PLA, PLA+, PETG, ASA, ABS, or ABS+
you cannot use filled, metallic, or silk filaments (these filaments typically hide defects)
the print must finish
the maximum nozzle or line width size is 0.5mm
the maximum layer height is 0.25mm
You may combine infill every other layer
You must record the whole print
you must use 3 top and bottom layers
you must use 2 walls and 10% infill
The finished print must be dimensionally accurate (within reason) bonus points if it looks good!
The machine must be powered by stepper motors
There must be a timer/clock shown in the video to verify its real time.(a phone is fine or you can show the time before and after the print)
You must share the profile !
You must post the video to Youtube and a link to said video in #speedboat_entries or the annex engineering subreddit
This is all in good fun and faith so just have fun!