Uploaded March 2013 | Updated November 2026, 1 day ago
If you enjoy my videos, Please consider contributing to my research.
Patreon: patreon.com/Limitless_Research
Inspired by TheRealVerbs, UCLA Research & many other YouTube videos on sonoluminescence & cavitation.
This video shows my attempt to reproduce sonoluminescence cavitation, also known as "Star in a Jar". I am using two high frequency transducers (60W, 40KHz), which I found on eBay for around $10 each. You can also use small piezoelectric speakers, which are less expensive. The frequency required varies with the amount of fluid you use and the size/shape of the container. Most of the research I found online say this occurs between 25KHz and 30KHz. This video shows the cavitation, which becomes visible in many different octaves starting around 26KHz, but the light isn't visible in the cavitations until 100KHz-270Khz. I found it best to move my setup to a dark room, wait a few minutes for my eyes to adjust then go through frequencies looking for light.
I have read that it is best to use distilled water and to "degas" the water by boiling it and letting it cool twice. This helps remove a lot of the infused gases that are trapped within the water. Some people add 10ml of glycerin to aid the reaction process. I used filtered water and boiled it twice. As you can see by my results, there is still a lot of trapped gas in my water.
New Test Results (04/01/2013):
Using a 100ml boiling flask sealed using a rubber stopper using the same transducers hot glued 180 degrees to each other and the water level located at the top of the sphere, these are my findings which produce the most light (Sonoluminescence).
Liquid: Distilled water, no additives
Temp: The colder the better (ideally 33F)
Frequency: Pulse width 80KHz, Space width 100KHz
Pressure: 10ml air removed from flask (estimated 1/3 to 1/5th atm)
At this point, I have only been able to produce multi-bubble sonoluminescence (MBSL). I hope to achieve single-bubble sonoluminescence (SBSL) and get it on film. Currently I do not have a camera capable of the necessary 1-2min exposures time needed to capture this on film. When/if I do, videos of my results will follow.
Set up & instructions
techmind.org/sl
Research:
http://www.physics.ucla.edu/Sonoluminescence/sono2.pdf
newsreview.com/sacramento/star-in-a-jar/content?oid=35071
http://www.pas.rochester.edu/~advlab/11-Sonolum/sono1.pdf
Other YouTube videos:
youtube.com/watch?v=LWO93G-zLZ0
youtube.com/watch?v=HuDyy4MTosA&NR=1&feature=endscreen
youtu.be/GJolILUbdNw
youtube.com/watch?v=7RHBRzsVS9A
Please leave your comments & suggestions. Constructive criticism is welcomed.
Thanks for watching,
Russell
If you enjoy my videos, Please consider contributing to my research.
Patreon: patreon.com/Limitless_Research
Inspired by TheRealVerbs, UCLA Research & many other YouTube videos on sonoluminescence & cavitation.
This video shows my attempt to reproduce sonoluminescence cavitation, also known as "Star in a Jar". I am using two high frequency transducers (60W, 40KHz), which I found on eBay for around $10 each. You can also use small piezoelectric speakers, which are less expensive. The frequency required varies with the amount of fluid you use and the size/shape of the container. Most of the research I found online say this occurs between 25KHz and 30KHz. This video shows the cavitation, which becomes visible in many different octaves starting around 26KHz, but the light isn't visible in the cavitations until 100KHz-270Khz. I found it best to move my setup to a dark room, wait a few minutes for my eyes to adjust then go through frequencies looking for light.
I have read that it is best to use distilled water and to "degas" the water by boiling it and letting it cool twice. This helps remove a lot of the infused gases that are trapped within the water. Some people add 10ml of glycerin to aid the reaction process. I used filtered water and boiled it twice. As you can see by my results, there is still a lot of trapped gas in my water.
New Test Results (04/01/2013):
Using a 100ml boiling flask sealed using a rubber stopper using the same transducers hot glued 180 degrees to each other and the water level located at the top of the sphere, these are my findings which produce the most light (Sonoluminescence).
Liquid: Distilled water, no additives
Temp: The colder the better (ideally 33F)
Frequency: Pulse width 80KHz, Space width 100KHz
Pressure: 10ml air removed from flask (estimated 1/3 to 1/5th atm)
At this point, I have only been able to produce multi-bubble sonoluminescence (MBSL). I hope to achieve single-bubble sonoluminescence (SBSL) and get it on film. Currently I do not have a camera capable of the necessary 1-2min exposures time needed to capture this on film. When/if I do, videos of my results will follow.
Set up & instructions
techmind.org/sl
Research:
http://www.physics.ucla.edu/Sonoluminescence/sono2.pdf
newsreview.com/sacramento/star-in-a-jar/content?oid=35071
http://www.pas.rochester.edu/~advlab/11-Sonolum/sono1.pdf
Other YouTube videos:
youtube.com/watch?v=LWO93G-zLZ0
youtube.com/watch?v=HuDyy4MTosA&NR=1&feature=endscreen
youtu.be/GJolILUbdNw
youtube.com/watch?v=7RHBRzsVS9A
Please leave your comments & suggestions. Constructive criticism is welcomed.
Thanks for watching,
Russell










