@maxmekkker
  @maxmekkker
Inges garage | Skyline GT-R: Upgraded cooling fans installation @maxmekkker | Uploaded October 2017 | Updated October 2024, 29 minutes ago.
My old cooling fans started making bad sounds. The old fans did not have rubber pads between the fan fittings and the radiator, so the fans had vibrated slightly into the radiator cords.
This video shows how I did when I replaced the fan for powerful fans.

The old fans constantly pulled draw 7 amps each. The new ones constantly draw about 12 amps each (mounted on the radiator). They are both of pull type, which are more effective than push type.

The old fans were already connected to Greddy MSS to control them. In the future, I will allow the ECU to do the job of managing them (fewer sources of error).
Greddy larger radiator was also mounted on my GT-R when I bought it.

Radiator Cooling Fan: Spal 12 "p. 30101504. Height 336mm (13.23"), width 321mm (12.64 "), thickness 63mm (2.48"). Max amps 25A.

Oil cooler fan: Spal 5.2 "p.n. 30103011. Height 132mm (5.21"), width 132mm (5.12 "), thickness 60mm (2.36"). Max amps 10A.

Live a comment if you have any questions, and I'll try to answer.
Skyline GT-R: Upgraded cooling fans installationBixler 2 flying over Lillestrøm, Norway FPVRC Tamiya Sand ScorcherNissan 200SX S13 CA18DETSkyline GT-R vs SupraTiger Moth with acrobatics!RC Sand Scorcher with 11,1V LiPoSpitfire FPV with headtrackerSkyline GT-R Vaalerbanen Racetrack 15th August 2021200SX Trackday Rudskogen 8.Mai 2010Leke med tørrisSkyline GT-R vs Tesla 90D

Skyline GT-R: Upgraded cooling fans installation @maxmekkker

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER