Uploaded July 2016 | Updated September 2026, 1 hour ago
Shredding solid kossel parts. It stalled on the second round of shredding. I guees i had too low stall setting in the VFD.
I haven't gone through all the settings in the VFD, just basic settings.
Must tune it to the motor correctly.
8-10 re-shred runs and it is small enough to go into the extruder.
Motor is a 1.5kw 380v 3 phase with about 50rpm out, but i run the VFD at 20-25hz so the rpm is about 25.
Shredding solid kossel parts. It stalled on the second round of shredding. I guees i had too low stall setting in the VFD.
I haven't gone through all the settings in the VFD, just basic settings.
Must tune it to the motor correctly.
8-10 re-shred runs and it is small enough to go into the extruder.
Motor is a 1.5kw 380v 3 phase with about 50rpm out, but i run the VFD at 20-25hz so the rpm is about 25.
