Uploaded December 2021 | Updated September 2026, 4 days ago

---

A quick video to show you how I set up to do a two sided tumbler engraving in Lightburn. This is the same process for any device that is compatible with Lightburn such as Aeon, Thunder, OMTech, Rabbit, Boss, and many others.

Lightburn Course
Course.beardedbuildsco.com/store

Support my content by using my affiliate resources and codes below.

I have many of the supplies that I use listed in Amazon affiliate store:
Amazon.com/shop/beardedbuildsco

OMTech Lasers:
omtechlaser.com/LSG

Affiliate code “LASERGUYS”
Coupon code “LASERGUYS5OFF”

OMTech Laser Facebook Group:
facebook.com/groups/1364016877267714/?ref=share

Socials:
Instagram.com/beardedbuildsco

Facebook.com/beardedbuildsco