Reinforcing Stair Treads - Hardware, Brackets & Stringer Upgrades Part 2 @stairbuilding
Reinforcing Stair Treads - Hardware, Brackets & Stringer Upgrades Part 2  @stairbuilding
Uploaded September 2026 | Updated November 2026, 3 hours ago
homebuildingandrepairs.com - Welcome to Part 2 of our series on structurally supporting a stairway! In this video, we explore different design ideas and framing methods to properly support the outside edge of your stair treads.

We’ll look at various custom block designs from simple square blocks to angled and curved cuts and discuss why certain shapes are better at preventing dangerous cantilever cracks. We also cover why upgrading from a 2x12 to a 4x12 might be necessary for a single stringer setup to provide adequate strength. Finally, I’ll show you how to use hardware brackets to connect to the floor framing, and how adding filler boards and 3/4-inch plywood can eliminate weak "hinge points" and prevent the stairs from twisting away from the center.

In this video, you will learn:

How to shape and angle support blocks for the outside of your stairs

Why a 4x12 is a safer bet for single stringer stairways

How to use brackets and hardware to secure the stringer to upper and lower floor framing

Techniques using plywood and filler boards to reinforce the left and right sides of the stairway

Disclaimer: The techniques shown in this video are suggested methods for assembly. Always check with your local building department or a licensed structural engineer to verify that these framing methods are approved for your specific area and project.

Don't forget to like, subscribe, and stay tuned for Part 3 where we dive into outside stringers!
Reinforcing Stair Treads - Hardware, Brackets & Stringer Upgrades Part 2Stair Building Masterclass - 7 Helpful Construction VideosBuilding Concrete Stairs Between Fixed Landings - Guide Board Layout and Mix RatiosStop Making This Mistake! - How to Measure Total Exterior Stair Rise ACCURATELY on Uneven LandingsBuilding Code 101 - Minimum Stair Tread DepthAvoiding Common Wood Tread Miter Mistakes and Exploring Design AlternativesHow to Build Russian-Style Winder Stairs - International CarpentryStairway Building Codes - Door Swings And Riser Height Rules ExplainedTread Thickness - The Missing Piece of Stair Layout For BeginnersLower Wood Rot Repair on Large Stair Stringers Without Removing And ReplacingStair Building Mastery Course - With Seven Videos For Do It Yourselfers And Pros - Part 3 - 2024Stair Building Tip - How to Count Treads (Its Not What You Think)
stairbuilding |

Reinforcing Stair Treads - Hardware, Brackets & Stringer Upgrades Part 2

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER