Uploaded February 2021 | Updated November 2026, 1 day ago
This exercise run on Raspberry Pi Pico/MicroPython, communicate with HC-08 via UART. helloraspberrypi.blogspot.com/2021/02/raspberry-pi-picomicropython-hc-08-ble.html
Firstly, it send a sequence of AT command to HC-08 to reset the module to factory setting, and read information about it.
Then stay in a loop to wait any income data from BLE, print on REPL terminal and each to BLE.
This exercise run on Raspberry Pi Pico/MicroPython, communicate with HC-08 via UART. helloraspberrypi.blogspot.com/2021/02/raspberry-pi-picomicropython-hc-08-ble.html
Firstly, it send a sequence of AT command to HC-08 to reset the module to factory setting, and read information about it.
Then stay in a loop to wait any income data from BLE, print on REPL terminal and each to BLE.










