Uploaded December 2023 | Updated November 2026, 18 hours ago
1000 C (1832 F) Electrical Kiln + Quartz Window: Programmable
Technical Supermarket (London)
Another worthy addition to the workshop.
Hopefully to be used for silver soldering Nickel wires to ceramic elements without risking cracking the elements as often happens with Oxy/Ace gear despite using a micro torch.
I would fit some silicon feet to this or strips of rubber or similar to avoid scratching the worksurface. At higher temperatures it may be necessary to put the kiln on a heat proof tiled surface.
On arrival I suggest removing the cover to the electronics, thanks for the tip Kev, and tighten all the terminals as required. The SSR terminals were loose on mine.
Make sure the factory first use heating program is run before you use this at high temperatures. That is 100 degs C for 10 minutes. run that if the kiln hasn't been used for a while as well.
A filtering fume chimney is available for this model as is a replacement element.
The kiln
kilnsandaccessories.com/product/1000-c-1832-f-electrical-kiln-quartz-window-programmable
The filter chimney
kilnsandaccessories.com/product/fume-filter-set-ff-122-for-r-14-r-9-brand-kilns
The element
kilnsandaccessories.com/product/quick-n-easy-changing-heating-element-for-r14-u-and-r14-up-kilns
Other spares like the SSR are available.
1000 C (1832 F) Electrical Kiln + Quartz Window: Programmable
Technical Supermarket (London)
Another worthy addition to the workshop.
Hopefully to be used for silver soldering Nickel wires to ceramic elements without risking cracking the elements as often happens with Oxy/Ace gear despite using a micro torch.
I would fit some silicon feet to this or strips of rubber or similar to avoid scratching the worksurface. At higher temperatures it may be necessary to put the kiln on a heat proof tiled surface.
On arrival I suggest removing the cover to the electronics, thanks for the tip Kev, and tighten all the terminals as required. The SSR terminals were loose on mine.
Make sure the factory first use heating program is run before you use this at high temperatures. That is 100 degs C for 10 minutes. run that if the kiln hasn't been used for a while as well.
A filtering fume chimney is available for this model as is a replacement element.
The kiln
kilnsandaccessories.com/product/1000-c-1832-f-electrical-kiln-quartz-window-programmable
The filter chimney
kilnsandaccessories.com/product/fume-filter-set-ff-122-for-r-14-r-9-brand-kilns
The element
kilnsandaccessories.com/product/quick-n-easy-changing-heating-element-for-r14-u-and-r14-up-kilns
Other spares like the SSR are available.










