Uploaded July 2023 | Updated November 2026, 14 hours ago
A 16 hour print.
The bed levelling had shifted after I took the base cover off, I should have levelled the bed again. The first layer showed the nozzle was too close on the right so I quickly adjusted the bed height.
Didn't turn out too bad but the lines in the longer wall are weird.
Is that layer shift? Like the corner oozing, I haven't seen that on the Ender 3 Pro either.
A 16 hour print.
The bed levelling had shifted after I took the base cover off, I should have levelled the bed again. The first layer showed the nozzle was too close on the right so I quickly adjusted the bed height.
Didn't turn out too bad but the lines in the longer wall are weird.
Is that layer shift? Like the corner oozing, I haven't seen that on the Ender 3 Pro either.










