Uploaded April 2021 | Updated September 2026, 2 weeks ago
In this video, Michael from Alarm Grid shows you how to enroll the Qolsys IQ Shock-S with the Qolsys IQ Panel 2 Security System. The Qolsys IQ Shock-S is a wireless shock sensor that operates at 319.5 MHz. It works with the original Qolsys IQ Panel 2, as well as the 319.5 MHz Qolsys IQ Panel 2 Plus. The sensor responds to the physical shock waves that occur when a door or window is broken down. You can also use it as a door and window contact sensor by turning ON sensor DIP Switch #3 and installing it alongside its included magnet.
The Qolsys IQ Shock-S enrolls with the Qolsys IQ Panel 2 by putting the system into its Auto-Learn Sensor Mode and then activating the tamper switch for the sensor. Once the system acknowledges the sensor, just confirm that you would like to enroll it, and then configure the zone settings. Before installing, you should open up the sensor and adjust its inside potentiometer to the desired level of sensitivity, and also configure the three (3) inside DIP switches to the proper positions based upon how you intend on using the sensor. It is a good idea to test the sensor after enrolling and installing it.
alarmgrid.com/faq/how-do-i-learn-the-qolsys-iq-shock-s-into-my-qolsys-iq-panel-2-p
http://alrm.gd/get-monitored
In this video, Michael from Alarm Grid shows you how to enroll the Qolsys IQ Shock-S with the Qolsys IQ Panel 2 Security System. The Qolsys IQ Shock-S is a wireless shock sensor that operates at 319.5 MHz. It works with the original Qolsys IQ Panel 2, as well as the 319.5 MHz Qolsys IQ Panel 2 Plus. The sensor responds to the physical shock waves that occur when a door or window is broken down. You can also use it as a door and window contact sensor by turning ON sensor DIP Switch #3 and installing it alongside its included magnet.
The Qolsys IQ Shock-S enrolls with the Qolsys IQ Panel 2 by putting the system into its Auto-Learn Sensor Mode and then activating the tamper switch for the sensor. Once the system acknowledges the sensor, just confirm that you would like to enroll it, and then configure the zone settings. Before installing, you should open up the sensor and adjust its inside potentiometer to the desired level of sensitivity, and also configure the three (3) inside DIP switches to the proper positions based upon how you intend on using the sensor. It is a good idea to test the sensor after enrolling and installing it.
alarmgrid.com/faq/how-do-i-learn-the-qolsys-iq-shock-s-into-my-qolsys-iq-panel-2-p
http://alrm.gd/get-monitored
